VM8000 Issue 1.0
InMail System Guide 2 - 67
3. Set the time limit for dialing commands for the Automated Attendant caller.
47-08-03 Time Limit for Dialing Commands (Dialing Timeout)
Enter the Time Limit for Dialing Commands interval (0~5 seconds).
By default, the interval is 5 seconds.
If the caller waits too long to dial:
Ì
When the associated Dial Action Table has a Timeout action
programmed, the caller routes to that destination.
Ì
When the associated Dial Action Table does not have a Timeout action
programmed, the Instruction Menu repeats three times and then
VM8000 InMail hangs up.
4. If using one key dialing from Auto Attendant to a stored speed dial number.
41-01-05 Message Wait
This program must be disabled (0) for one key dialing to a speed dial buffer
from Auto Attendant to work.
By default, this feature is enabled.
Operation
Not applicable
To Next Page
Loading...
