2 - 6 Chapter 2
Chapter 2 - MH240 Setup
WPA: TLS: Factory Default: WPA2-PSK (1.NEC-SETUP), OPEN (2 to 9)
1. Press 3 (Security) to go to the Security setting screen.
2. Press
▲
▼
to select “WPA” and then press the round OK key.
3. Press
▲
▼
to select an encryption “1.TKIP” or “2.AES” and then press the round OK key.
4. Press 1 (EAP) + 1 (TLS) to set EAP type to TLS.
5. Press 2 (Identity) to go to the Identity edit screen.
6. Edit the Identity and then press the “OK” soft key.
7. Press 4 (Password) to go Password edit screen.
8. Edit the Password and then press the “OK” soft key.
9. Press 5 (CA Cert.) + 1 (Set Cert.) then “OK” to set CA Certificate (cacrt.pem).
10. Press 6 (User Cert.) + 1 (Set Cert.) then “OK” to set User Certificate (usercrt.pem).
11. Press 7 (Private Key) + 1 (Set Cert.) then “OK” to set Private Key
(userkey.pem).
12. Press HOLD as needed to exit back to the Profile Setting (
Prof. Setting) screen.
13. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
NOTE: You should upload CA Certificate “cacrt.pem”, User Certificate “usercrt.pem” and
Private Key “userkey.pem” to MH240 in advance by using IP Phone Manager for MH240.
WPA2: PEAP: Factory Default: WPA2-PSK (1.NEC-SETUP), OPEN (2 to 9)
1. Press 3 (Security) to go to the Security setting screen.
2. Press
▲
▼
to select “WPA2” and then press the round OK key.
3. Press
▲
▼
to select an encryption “1.TKIP” or “2.AES” and then press the round OK key.
4. Press 1 (EAP) + 2 (PEAP) to set EAP type to PEAP.
5. Press 2 (Identity) to go to the Identity edit screen.
6. Edit the Identity and then press the “OK” soft key.
7. Press 4 (Password) to go Password edit screen.
8. Edit the Password and then press the “OK” soft key.
9. Press 5 (CA Cert.) + 1 (Set Cert.) then “OK” to set CA Certificate (cacrt.pem).
10. Press HOLD as needed to exit back to the Profile Setting (Prof. Setting) screen.
11. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
NOTE: You should upload CA Certificate “cacrt.pem” to MH240 in advance by using IP
Phone Manager for MH240.
To Next Page
Loading...
