3-16 Using the BIOS Setup Utility
6. Press Y and then press Enter. A message informs you of the
update progress. Do not restart the system until the you are
instructed to restart.
Interrupting the BIOS update during the
update process can cause damage to the system.
7. Remove the diskette and press any key to continue. A CMOS
Checksum message appears and prompts you to press
DOWN to
enter Setup.
8. Press DOWN to enter Setup and restore the default parameter
settings.
9. Reconfigure Setup with the custom settings you documented for
yourself before beginning this procedure.
10. Press F10 to save changes and exit Setup.
Checking/Changing Switch Settings
The NEC Versa LitePad tablet PC has a four-position dip switch on the
bottom of the tablet PC. Switches are identified as follows:
Switch 1 — Password Override switch
The default setting is “OFF.” If you forget the password you set in
the BIOS Setup utility and you cannot access BIOS Setup or
Windows, change the setting to “ON” and your current password is
erased.
Note Clearing the password set in the BIOS Setup utility does not
clear your Windows password.
Switch 2 — Logo Select switch
The default setting is “OFF” for the U.S. logo.
Switch 3 — Crisis Recovery Boot from Boot Block switch
The default setting is “OFF” for a Normal boot. The “ON” setting
is for a Boot block.
Switch 4 — Reserved for factory use. Default setting is “OFF.”
To Next Page
Loading...