2
R900 cellular endpoint Wall and Pit Installation and Maintenance Guide
Chapter 2: Specifications
This chapter covers the specifications for the R900 cellular endpoint.
Electrical Specifications
Transmitter
The power is supplied by a lithium battery.
The following table defines the R900 cellular endpoint transmitter specifications.
Table 1 – Transmitter Specifications
Encoder Register Interface
The following table provides information on the maximum cable lengths required for
different registers.
Table 2 – Supported Encoder Maximum Cable Length
Transmit Period
Encoder Reading
Output Power
-minute readings delivered four times per
-minute.
Meets FCC Part 15.247 and FCC Part 27.
®
ARB
®
V
®
ProRead™,
®
,
-CODER
®
Sensus Protocol registers
feet (91 meters). Meets manufacturer's published
wire length between the encoder and the
receptacle. The length is based on solid three
22 AWG.
To Next Page
Loading...
Need help?
General
