R900 cellular endpoint Wall and Pit MIU Installation and Maintenance
19
Chapter 4: Wall
3.
Position the magnet against the left side of the R900 cellular endpoint directly in
line with the Neptune logo.
4.
Move the magnet up and over the top left corner of the R900 cellular endpoint.
Figure 19 – Swiping the R900 cellular endpoint
5.
Install a seal wire or seal clip through the seal hole at the bottom of the R900 cellular endpoint main
housing.
Figure 24 – Installing the Seal Wire
6.
Verify that the requirements of the site work order have been met and that you have
recorded all information.
7.
Clean up the installation site before leaving.
To Next Page
Loading...
Need help?
General
