R900 cellular endpoint Wall and Pit MIU Installation and Maintenance Guide
31
7.
Squeeze the connector firmly with the proper crimping tool until you hear a pop and gel
leaks out the end of the connector.
8.
Repeat steps two through six for each color wire.
9.
After connecting all three color wires, read the encoder register to ensure proper
connections, and the R900 cellular endpoint is functioning properly.
Figure 41 – Three Colored Wires Properly Connected
Connecting the Splice Tube
To finish installing the Scotchloks, complete the following steps to install the connector king
splice tube.
1.
Take all three connected Scotchloks and push them into the splice tube until fully
encapsulated by the silicone grease.
Figure 42 – Splice Tube
2.
Separate each gray wire and place them in the slots on each side.
To Next Page
Loading...
Need help?
General
