16
R900 cellular endpoint Wall and Pit MIU Installation and Maintenance Guide
Chapter 4: Wall Installation
2.
Study "Site Selection" on page 14 and then decide how to install the R900 cellular endpoint.
You can insert the cable through any of the entry holes in the back of the mounting
adapter. A variety of holes allows for a quick and easy installation.
Figure 13 – R900 cellular endpoint Back Plate
When the R900 cellular endpoint replaces a receptacle, use the appropriate hole to
allow reuse of the receptacle's original mounting holes.
When mounting the R900 cellular endpoint to a pipe, use the pipe clamp holes to
secure the mounting adapter to a pipe.
Applying the Scotchlok™ Gel Caps
Follow this procedure to apply the Scotchlok™ gel caps.
1.
Using Scotchlok gel caps, connect the register to the pigtail from the R900 cellular endpoint.
Figure 14 – Gel Cap Connectors
The Hi-Lo fastener for securing the main R900 cellular endpoint housing to the
adapter plate is shipped separately.