Information needed Your value
Network bond mode Choose one:
• Active-Backup (default)
• LACP (802.3ad)
VLAN tagging enabled Choose one:
• No (default)
• Yes
VLAN tag
(If VLAN tagging is enabled)
Enter a value between 0 and 4095:
DHCP-assigned IP address for the Client
Network, if available after power on
• IPv4 address (CIDR):
• Gateway:
Static IP address you plan to use for the
appliance Storage Node on the Client Network
Note: If the Client Network is enabled, the
default route on the controller will use the
gateway specified here.
• IPv4 address (CIDR):
• Gateway:
Table 6: Information needed to connect the SG6000-CN controller to the BMC
management network
You can access the BMC interface on the SG6000-CN controller using the following 1-GbE
management port. This port supports remote management of the controller hardware over Ethernet
using the Intelligent Platform Management Interface (IPMI) standard.
Information needed
Your value
Ethernet switch port you will connect to the
BMC management port (circled in the diagram)
DHCP-assigned IP address for the BMC
management network, if available after power
on
• IPv4 address (CIDR):
• Gateway:
Static IP address you plan to use for the BMC
management port
• IPv4 address (CIDR):
• Gateway:
Related concepts
10/25-GbE port connections for the SG6000-CN controller
on page 16
22
| Hardware Installation and Maintenance Guide for SG6000 Appliances
To Next Page
Loading...
Need help?
General
