sgamaintenance
The following messages are displayed on the service laptop:
WARNING: All StorageGRID Webscale services on this node will be
shut down.
WARNING: You will have to manually exit maintenance mode before
this node will resume normal operation.
After running this command and waiting a few minutes for the node
to reboot, browse to one of the following URLs to perform any
maintenance actions, then exit maintenance mode:
http://192.168.4.138:8080
http://10.224.4.138:8080
http://47.47.4.138:8080
http://169.254.0.1:8080
Are you sure you want to continue (y/n)?
d. Enter y to continue.
The appliance reboots, which takes two or three minutes to complete.
e. Browse to any of the URLs displayed in the output of the sgamaintenance command to
access the StorageGRID Appliance Installer.
Note: If possible, use the URL containing the IP address of this StorageGRID Webscale
appliance's Admin Network port. Connectivity through the grid or Client Network IP
addresses might be interrupted by steps you complete later in this procedure.
Note: Accessing http://169.254.0.1:8080 requires a direct connection to the
rightmost RJ-45 port on the SG6000-CN controller.
f. Confirm that the appliance is in maintenance mode by noting the maintenance mode message
on the StorageGRID Appliance Installer home page.
2. From the StorageGRID Appliance Installer, select Configure Networking > Link
Configuration.
3. Make the desired changes to the link configuration.
For more information on the options, see “Configuring network links.”
4. When you are satisfied with your selections, click Save.
Maintaining the SG6000 appliance |
77
To Next Page
Loading...
Need help?
General
