Note: You might lose your connection if you made changes to the network or link you are
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
StorageGRID Appliance Installer using one of the other IP addresses assigned to the appliance:
http://SG6000-CN_Controller_IP:8080
5. Select Configure Networking > Ping Test from the menu.
6. Use the Ping Test tool to check connectivity to IP addresses on any networks that might have been
affected by the link configuration changes you made in step
3
.
In addition to any other tests you choose to perform, confirm that you can ping the Grid Network
IP address of the primary Admin Node, and the Grid Network IP address of at least one other
Storage Node. If necessary, return to step
3
, and correct any link configuration issues.
7.
Once you are satisfied that your link configuration changes are working, return the appliance to
normal operating mode:
a. From the StorageGRID Appliance Installer, select Advanced > Reboot Controller.
b. Click Reboot Controller.
The appliance reboots and rejoins the grid. This process can take up to 20 minutes.
c. Monitor the status of the upgraded appliance Storage Node in the Grid Manager.
Verify that the appliance returns to the expected status.
Related tasks
Configuring network links
on page 44
78 | Hardware Installation and Maintenance Guide for SG6000 Appliances
To Next Page
Loading...
Need help?
General
