Installation Guide for the Model FS562 and Model FS566 Fiber Switches
Physical Description 2-5
LEDs
The LEDs on the front panel of the switch and two vista LEDs on each RJ-45 connector allow you
to identify the following information:
• Status of the switch power supply
• For each 10/100 Ethernet port:
– Network link at 10 Mbps or 100 Mbps
– Data transmission or receive activity
– Collision occurrence
– Full-duplex or half-duplex mode
• For each fiber port:
– Link status (fiber ports operate only at 100 Mbps)
To Next Page