NETGEAR GC510P User Manual

• Rack-mounting screws
• Installation guide
• Rubber footpads for tabletop installation
5. If any item is missing or damaged, contact your local NETGEAR reseller for replacement.
Step 4: Install the Switch
You can also use any off-the-shelf 75 mm VESA standard mount to secure the switch to a wall, a pole, or
another surface.
You can place the switch on a flat surface, attach it to a wall, or install it in a standard 19-inch
(48.26-centimeter) network equipment rack.
Install the Switch on a Flat Surface
The switch ships with four self-adhesive rubber footpads.
To install the switch on a flat surface:
Stick one rubber footpad on each of the four concave spaces on the bottom of the switch.
The rubber footpads cushion the switch against shock and vibrations.They also provide ventilation
space between stacked switches.
Wall-Mount the Switch
The bottom panel of the switch provides four VESA mount holes that allow you to mount the switch to a
wall.The switch ships with wall-mount screws and anchors that you can secure to a wall and attach the
switch to.We recommend that you use all four screws for greater stability and correct positioning. Although
for some positions you could use only two screws, for other positions, using two screws will cause the switch
to tilt.
To prevent the switch from tilting, do not wall-mount the switch vertically with the back
panel facing right (that is, with the cables on the right). Whether you use two or four
screws, the switch will tilt in this position.
Note
Installation
25
Insight Managed 8-Port Gigabit Ethernet PoE+ Smart Cloud Switch with 2 SFP Fiber Ports

NETGEAR GC510P Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
Installed SFP modules quantity	2
Installed SFP+ modules quantity	0
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
10G support	No
Networking standards	-
MAC address table	- entries
Product color	Gray
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Total Power over Ethernet (PoE) budget	134 W
Operating temperature (T-T)	0 - 45 °C

Weight and Dimensions

Depth	188 mm
Width	314 mm
Height	44 mm
Weight	2010 g