EasyManuals Logo

NETGEAR Wireless-N 150 User Manual

NETGEAR Wireless-N 150
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
Wireless-N 150 ADSL2+ Modem Router DGN1000 User Manual
Advanced Configuration 5-3
v1.1, January 2010
Setting Up a Default DMZ Server
The default demilitarized zone (DMZ) server feature is helpful when you use some online games
and videoconferencing applications that are incompatible with NAT. The wireless modem router is
programmed to recognize some of these applications and to work correctly with them, but there
are other applications that might not function well. In some cases, one local computer can run the
application correctly if that computer’s IP address is entered as the default DMZ server.
Note: For security reasons, you should avoid using the default DMZ server feature. When
a computer is designated as the default DMZ server, it loses much of the protection
of the firewall, and is exposed to many exploits from the Internet. If compromised,
the computer can be used to attack your network.
Incoming traffic from the Internet is usually discarded by the wireless modem router unless the
traffic is a response to one of your local computers or a service that you have configured in the
Ports screen. Instead of discarding this traffic, you can have it forwarded to one computer on your
network. This computer is called the default DMZ server.
How to Configure a Default DMZ Server
To assign a computer or server to be a default DMZ server:
MTU Size (in bytes) The normal MTU (Maximum Transmit Unit) value for most Ethernet networks
is 1500 bytes, or 1492 bytes for PPPoE connections. For some ISPs you
might need to reduce the MTU. But this is rarely required, and should not be
done unless you are sure it is necessary for your ISP connection.
Disabling the SIP ALG The Session Initiation Protocol (SIP) Application Level Gateway (ALG) is
enabled by default to optimize VoIP phone calls that use the SIP. The Disable
SIP ALG check box allows you to disable the SIP ALG. Disabling the SIP ALG
might be useful when running certain applications.
Table 5-1. WAN Setup Settings (continued)
Setting Description

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR Wireless-N 150 and is the answer not in the manual?

NETGEAR Wireless-N 150 Specifications

General IconGeneral
BrandNETGEAR
ModelWireless-N 150
CategoryNetwork Router
LanguageEnglish

Related product manuals