OPRHT70 A0310
4-9
Navigating the Screens
4
NOTE: To increase or decrease the parameter setting rapidly, press
and hold the s or t button down until the desired value appears.
8. Monitor Data buttons (four):
To choose and change the parameters displayed on the Monitor
Data buttons (located at the bottom of the screen) press any one of
the buttons to select it. A new screen appears that shows the nine
parameters available. Touch the parameter that you would like to display.
That parameter will automatically appear in the Monitor Data button that
was selected. You can arrange these parameters in the order you wan
t.
NOTE: You do not have to push Accept to complete your change.
9. Messages and Alerts Display: Messages, including alarm alerts,
are displayed in the message display area of the screen in order of
priority. Active alarms are displayed first followed by latched alarms
that have not been cleared by the user.
To clear alarm messages: Press the Alarm Silence/Reset button
(located on the top of the panel). As you clear each alarm message,
the alarm message with the next priority will appear in the message
display area. Continue pressing to clear all alarm messages.
10. Battery Charge Level Display: A battery icon is displayed in the
upper right corner of the screen. This icon indicates the percent of
charge level of the battery that is operating the ventilator - either the
Power Pac battery pack (blue icon) or the Backup Battery (red icon).
11. Additional Screen Selections Available from Main Screen:
From the Main screen you can choose to view these additional
screens: Advance, Trends, Events and Alarms. Simply touch the
To Next Page
Loading...