PART 1
INTRODUCTION
1.1 Safety and EMC Considerations
This device is a stand alone low voltage (5Vdc) Ethernet Server to be integrated into a
design or system. Installation of this device should be done by qualified personnel and
should follow electrical safety requirements in accordance to EN 61010-1:2001 or
EN 60950 safety standards.
EMC Considerations
• Whenever EMC is an issue, always use shielded cables.
• Never run signal and power wires in the same conduit.
• Use signal wire connections with twisted-pair cables.
• Install Ferrite Bead(s) on signal wires close to the instrument if EMC problems persist.
Failure to follow all instructions and warnings may result in injury!
1.2 Before You Begin
Inspecting Your Shipment:
Remove the packing slip and verify that you have received everything listed. Inspect the
container and equipment for signs of damage as soon as you receive the shipment. Note
any evidence of rough handling in transit. Immediately report any damage to the shipping
agent. The carrier will not honor damage claims unless all shipping material is saved for
inspection. After examining and removing the contents, save the packing material and
carton in the event reshipment is necessary.
Customer Service:
If you need assistance, please contact the Customer Service Department nearest you.
Manuals, Software:
The latest operator’s manual as well as free iServer configuration software (iCONNECT)
and iServer Mail Notifier software are available at the WEB site listed on the cover
page of this manual. They may also be on the CD-ROM enclosed with your
shipment.
2
To Next Page
Loading...