XPS-Q8 Controller Motion Tutorial
G1.P1. The type of data that gathered is defined with the function
GatheringConfigurationSet (CurrentPosition of positioner G1.P1). To store the data
from internal memory to the flash disk in the XPS controller, send the function
GatheringStopAndSave(). The GatheringRun deletes the current data file in internal
memory (in contrast to the GatheringOneData which appends data to the current
file). Also, the function GatheringStopAndSave() stores the data file under a default
name Gathering.dat on the flash disk of the XPS controller and will overwrite any
older file of the same name in the same folder. Hence, make sure to store valuable
data files under a different name before a GatheringStopAndSave().
NOTE
When using the function EventExtendedConfigurationTriggerSet() or
EventExtendedConfigurationActionSet () from the terminal screen of the XPS
utility, the syntax for one parameter is not directly accessible. For instance, for the
event XY.X.SGamma.MotionStart, first select XY.X from the choice list. Then,
click on the choice field again and select SGammaMotionStart. See also screen
shots below.
For specifying more than one data type, use the ADD button. Select the next
parameter as described above.
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17) 146
To Next Page
Loading...
