XPS-Q8 Controller Software Tools
4.13 FRONT PANEL – Jog
The Jog page allows executing a jog motion. A jog motion is a continuous motion,
where only the speed and acceleration are defined, but no target position. Speed and
acceleration can be changed during the motion (but not during the acceleration period).
For a Jog motion, the jog mode must be enabled, see “Action” button.
4.14 FRONT PANEL – Spindle
The Spindle page provides similar functions to the Jog page. However, specific jog
actions are replaced by spindle actions that only work for Spindle groups.
53 XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
To Next Page
Loading...
