XPS-Q8 Controller User’s Manual
2.6 Rear Panel Description
Figure 8: Rear Panel of XPS Controller/Driver.
NOTE
The Main Power ON/OFF Switch is located above the inlet for the power cord. The
switch and the inlet must be accessible to the user.
2.6.1 Axis Connectors (AXIS 1 – AXIS 8)
Each installed axis driver card features a connector to attach a cable (supplied with
every Newport stage) between the controller and a motion device.
CAUTION
Carefully read the labels on the driver cards and make sure the
specifications (motor type, voltage, current, etc.) match those of the
motion devices you intend to connect. Severe damage could occur if a
stage is connected to the wrong driver card.
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17) 10
To Next Page
Loading...
