XPS-Q8 Controller User’s Manual
5. Click “OK”.
NOTE
The The Last number of the IP address must be set to any number between 2 to
253: 100 for example.
NOTE
When configuring the controller to be on the network, the settings for the PC’s
Ethernet card will have to be set back to default under “Obtain an IP address
automatically”.
Once the Ethernet card address is set, you are ready to connect to the XPS controller.
Following is the procedure for connecting to the controller:
6. Open Internet Browser and connect to http://192.168.0.254
in case using HOST
connector or connect to http://192.168.254.254 in case using REMOTE connector
Login:
Name: Administrator
Password: Administrator (Please see the picture below).
Rights: Administrator
NOTE
Please note that the login text is case sensitive.
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17) 18
To Next Page
Loading...
