XPS-Q8 Controller User’s Manual
Remove the REMOTE cable and, if needed, configure your PC back to its original
Ethernet configuration, you have saved before modification.
Make sure that the standard CAT-5 network cable (black) is connected to the HOST
connector of the XPS controller and to your network.
Open your internet browser and use the dynamic IP address.
Check with your IT department that the lease time set at the DHCP is longer than the
time you plan to leave the XPS switched off otherwise you will lose your dynamic
address and will need to connect to the REMOTE to know the new assigned one by the
DHCP.
NOTE
Do not use Dynamic IP configuration if your DHCP server uses Windows NT 4.0
23 XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
To Next Page
Loading...
