NewTek 3Play 3P1 - AMP Control

Page | 162
CLIP_ PLAY
Delay (ms)
Shortcut
Value
Key 1
Value 1
Key 2
Value 2
(time)
net#
clip_ play
speed
#
position
#
You can specify “speed”, “position” or both keys (the order of keys is not important).
When “position” is not specified, play begins at the current frame. The value for position is specified in
seconds, while speed is expressed as a playback rate value (1.0 = 100%).
For example:
Delay (ms)
Shortcut
Value
Key 1
Value 1
Key 2
Value 2
(time)
net#
clip_ play
speed
-.5
position
10
This entry would play a clip backwards at 50% speed from a position 10 seconds into the clip.
CLIP_ SCRUB
Delay (ms)
Shortcut
Value
Key 1
Value 1
(time)
net#
clip_ scrub
distance
#
This command will move the playhead backward or forward by a distance of # seconds. For example:
Delay (ms)
Shortcut
Value
Key 1
Value 1
(time)
net#
clip_scrub
distance
5
The entry above would advance the playhead five seconds further into a clip displayed on the source
connected to the network input designated.
NOTES: The software associates values with their key name, thus key can be entered in any order. The
following are valid formats for numeric entries: “+0.1”, “0.1”, “.1”, “-0.1”.
17.7 AMP CONTROL
AMP stands for Advanced Media Protocol. The original implementation by Odetics Broadcast
Corporation® provides a variety of commands, which over time have been applied and extended by other
developers according to their requirements.