NOTE
During floor drying the heating medium pump
in 100% runs regardless of the setting in menu
5.1.10.
TIP
If operating mode "add. heat only" is to be
used, select it in menu 4.2.
Menu 5.10 - change log
Read off any previous changes to the control system
here.
The date, time and ID no. (unique to certain settings)
and the new set value is shown for every change.
NOTE
The change log is saved at restart and remains
unchanged after factory setting.
Menu 5.11 - slave settings
Settings for installed slaves can be made in the sub
menus.
Menu 5.11.1 - EB101
Make settings for the installed slaves here.
Menu 5.11.X.1 - heat pump
Make settings for the installed slave here. To see what
settings you can make, see installation manual for the
relevant installed slave.
Menu 5.11.X.2 - charge pump
op. mode
Setting range: auto / manual
Default value: auto
Set the speed at which the charge pump is to operate
in the present operating mode.
auto: The charge pump selects optimal speed for the
current operating mode for VVM 310.
manual: The speed of the charge pump is adjustable
between 0 and 100%.
NIBE™ VVM 310Chapter 8 | Control - Menus54
To Next Page
Loading...
