AD3000 1 - SCOPE
NIDEC ASI S.P.A. – AD3000 COMMUNICATION MANUAL
IMAD30007EN 1
1 SCOPE
The purpose of this manual is to provide instructions about the installation and programming of the optional fieldbuses available on the AD3000
drive series.
The Modbus RTU fieldbus is available as a standard on AD3000 drive without any optional board and it is described in the Programming
Manual and in the User and Maintenance Manual.
To provide an optional fieldbus it is necessary to insert an optional board on the drive control board (BASIS). The hardware characteristics and
necessary configuration of these optional boards are described in this manual.
The optional fieldbuses available for the AD3000 drive are:
PROFIBUS DP by inserting the PROFIBUS DP and Modbus TCP communication module (ETH-PROFI board)
Modbus TCP by inserting the PROFIBUS DP and Modbus TCP communication module (ETH-PROFI board)
PROFINET IO by inserting the PROFINET IO communication module (GB40A-PROFINET board)
EtherNet/IP by inserting the EtherNet/IP communication module (GB40A-EtherNet/IP board)
This manual, together with the Programming Manual and the User and Maintenance Manual, is part of the equipment and has to be stored in a
safe and easily accessible place for the whole lifetime of the AD3000 drive.
The manuals are identical and apply to all models and types, electrical schematic diagrams and mechanical drawings are specific for each size.
Only actions described in these manuals shall be performed on equipment. Neither any other action, measurement nor change of any type
shall be carried out.
This Communication Manual is updated in line with the software release: 3.16.2.0_0000-3G1602B1.
To Next Page
Loading...
Need help?
General