139
Technical Notes
Error Messages During Wireless Transfer Mode
* For more information, see the manual for the optional PD-10 wireless printer adapter.
Display Problem Solution Page
Transfer error
u
Error occurred when
images were trans-
ferred to computer.
Check signal. Move the camera closer
to the printer. Remove any obstacles
between camera antenna and profile
device.
–
Profile not registered.
Set up profile.
u
A profile for wireless
transfer has not been
set.
Set profile device with Wireless Camera
Setup Utility or the optional PD-10
wireless printer adapter.
P.114
u NETWORK
CONNECTION FAILED
Camera could not con-
nect to wireless net-
work.
Check selected computer or access
point.
Check network settings.
P.123
Battery exhausted.
Transfer terminated.
w
Battery has become
depleted while images
were being transferred.
Charge battery and turn camera on in
Wireless transfer mode.
P.16
u Failed to connect to
XXX
Camera could not con-
nect to selected profile
device (computer).
Check selected computer. P.123
Connection error.
u
Wireless connection
with the profile device
stopped while camera
was connected to the
network.
Check signal. Move the camera closer
to the printer. Remove any obstacles
between camera antenna and profile
device.
–
Failed to register
printer profile.
u
Printer profile for wire-
less transfer could not
be set.
Check that the printer is on and ready
to print.*
–
UNABLE TO CONNECT TO
WIRELESS PRINTER
ADAPTER.
u
Camera could not con-
nect to wireless printer
adapter.
Check signal. Move the camera closer
to the printer. Remove any obstacles
between camera antenna and profile
device.
–
To Next Page
Loading...
