12
Accessories
After unpacking the scanner, check that the package contains all the items listed below. Contact your
retailer immediately should you find that anything is missing or damaged.
IEEE 1394/Firewire interface board (1)
(includes user’s manual)
(4000 ED only)
If you are using a Windows or old-model (beige)
Macintosh G3 desktop computer, you may need to in-
stall this PCI board before you will be able to connect
your scanner to your computer. This board can not
be used with laptop computers or computers not
equipped with a PCI slot, and is not required in the
case of Macintosh computers with built-in Firewire
ports.
IEEE 1394/Firewire interface cable (1)
(4000 ED only)
Use this cable to connect the 4000 ED to your com-
puter.
USB interface cable (1)
(
COOLSCAN IV ED
only)
Use this cable to connect the
COOLSCAN IV ED
to
your computer.
Power cable (1)
(shape of cable depends on country of sale)
MA-20 (S) slide-mount adapter (1)
Use this adapter to scan mounted slides, or with the
FH-3 to scan strip film too short or too badly dam-
aged to be used in the SA-21.
FH-3 strip-film holder for MA-20 (S) (1)
Place strip film to be scanned in this holder before
scanning it with the MA-20 (S).
SA-21 strip-film adapter (1)
This adapter can be used to scan single or multiple
selected frames in film strips two to six frames in length.
The frames to be scanned can be previewed and se-
lected using Nikon Scan.
To Next Page
Loading...
Need help?
General