85
Cleaning the Scanner
Before cleaning the scanner, turn it off and unplug the power cord. The front of the scanner is made of
plastic, and consequently cannot be cleaned with volatile cleaners such as alcohol or paint thinner. Use
a blower to blow off dust or wipe the surface with a dry cloth. Remove dirt from the metal rear panel
of the scanner using a soft, dry cloth. If this is not sufficient to remove all dirt, clean with a cloth that has
been slightly dampened with a neutral detergent or liquid soap.
Transporting the Scanner
Follow the steps below to prepare the scanner for transport.
1. Remove any adapters and close the sliding cover.
2. Turn the scanner on.
3. Wait for the status LED on the front of the scanner to stop blinking.
4. Turn the scanner off.
5. Disconnect the power and interface cables.
6. After checking that no film remains in the adapters, package the scanner and adapters in the original
packing materials.
Nikon scanners are certified for use in the country or region of sale. Transportation and use outside the
country or region of sale are at the user’s own risk and responsibility.
Where the original packing materials are not available, package the scanner carefully in materials at least
as shock resistant as the originals.
To Next Page
Loading...
Need help?
General