vi
CAUTIONS
Do not place heavy objects on the equipment
Do not place heavy objects on the equipment, as either the objects or the equipment could overbal-
ance or fall, causing injury.
Save where indicated otherwise, do not put your fingers into the equipment
Failure to observe this precaution could result in injury.
Unplug the equipment when not in use
For your safety, turn off and unplug the scanner when you do not intend to use it for an extended
period. Failure to observe this precaution could result in fire.
Unplug the equipment before cleaning
For your safety, turn off and unplug the scanner when cleaning the equipment.
Place on a stable surface
• Do not use the equipment on an unstable surface or on a surface that is not level. The equipment
could fall, resulting in injury or in damage to the scanner.
• The scanner contains glass parts. Caution is advised in the event of breakage to prevent injury
from broken glass.
Observe appropriate precautions when handling the power cable
• Do not place the power cable in the vicinity of a stove or heater, as this could melt the insulation,
resulting in fire or electric shock.
• Unplug the cable by the plug, never by pulling on the cord itself. Failure to observe this precaution
could damage the cord, resulting in fire or electric shock.
• Do not plug the power cable into an extension cord or multi-outlet adapter, as this could cause
fire or malfunction.
Ground the equipment
• The outlet into which the power cable is plugged must be grounded. Failure to ground the power
supply could result in electric shock.
• Do not ground the outlet to a gas or water pipe or a dedicated telephone system earth connec-
tor. Failure to observe this precaution could result in fire or electric shock.
Do not handle the equipment when your hands are wet
Failure to observe this precaution could result in electric shock.
Keep equipment out of reach of children
Failure to observe this precaution could result in injury.
Install the scanner only as directed in this manual
Failure to observe this precaution could block the scanner’s vents and cause the power source to
overheat, possibly resulting in fire.
To Next Page
Loading...
Need help?
General