Nikon D3 VBA18001 - Page 56

- Ａ  ･ -
VBA18001-R.3719.A
logo�Q0440�forGraphic
070518�Gdesign�ito
・
Mount the charge base plate unit (#B10620).
・
Tighten the screw (#1706).
・
Tighten one screw (#1710) and two screws
(#1709).
・
Fit the FPC with the boss.
・
Make six soldering bridges and four soldering bridges.
Shutter unit
Soldering bridge × 4
Boss
Soldering bridge × 6
#1710
#1709×2
#1706
#B10620
#1567
#B665
#622
#B602
#1705×3
#624×3
Charge base unit (#B10620)
Grease: G92-KA
Mount the charge lever by engaging
with the convex portion of the shutter.
Charge base unit
#1509×2
#1505
#B12001
Positioning
・
Mount the shutter unit (#B12001) in the direction for positioning.
・
Tighten two screws (#1509) and one screw (#1505).
INC