170
r
4 Select direct measurement mode.
Release the U button briefly and then
press the button until the L icon in
the rear control panel starts to flash.
A
spot white balance target (r) will be
displayed at the selected focus point.
5 Position the target over a white or grey area.
While L flashes in the display, use the
multi selector to position the r over a
white or grey area of the subject.
To
zoom the area around the target in for
more precise positioning, press the X
button.
6 Measure white balance.
Press the center of the multi selector or
press the shutter-release button all the
way down to measure white balance.
The time available to measure white
balance is that selected for Custom
Setting c4 (Monitor off delay) > Live
view (0 325).
If the camera is unable to measure white
balance, the message shown at right will
be displayed.
Choose a new white
balance target and repeat the process
from Step 4.
Rear control panel
To Next Page
Loading...
