411
n
Software
• Capture NX 2: A complete photo editing package with such
advanced editing features as selection control points and
an auto retouch brush.
• Camera Control Pro 2: Control the camera remotely from a
computer and save photographs directly to the computer
hard disk.
When Camera Control Pro 2 is used to capture
photographs directly to the computer, a PC connection
indicator (c) will appear in the top control panel.
Note: Use the latest versions of Nikon software; see the websites
listed on page xx for the latest information on supported
operating systems.
At default settings, Nikon
Message Center 2 will periodically check for updates to Nikon
software and firmware while you are logged in to an account
on the computer and the computer is connected to the
Internet.
A message is automatically displayed when an
update is found.
Body caps
Body Cap BF-1B/Body Cap BF-1A: The body cap keeps the mirror,
viewfinder screen, and low-pass filter free of dust when a
lens is not in place.
Wireless
remote
controllers
• Wireless Remote Controller WR-R10/WR-T10: When a WR-R10
wireless remote controller is attached to ten-pin remote
terminal using a WR-A10 adapter, the camera can be
controlled wirelessly using a WR-T10 wireless remote
controller.
• Wireless Remote Controller WR-1: WR-1 units are used with
WR-R10 or WR-T10 wireless remote controllers or with
other WR-1 remote controllers, with the WR-1 units
functioning as either transmitters or receivers.
For
example, a WR-1 can be attached to the ten-pin remote
terminal and used as a receiver, allowing the shutter to be
released remotely by another WR-1 acting as a
transmitter.
To Next Page
Loading...
