Nikon D4s - Page 434

412
n
Remote
terminal
accessories
The D4S is equipped with a ten-pin remote terminal (0 2)
for remote control and automatic photography.
The
terminal is provided with a cap, which protects the contacts
when the terminal is not in use. The following accessories
can be used (all lengths are approximate):
• Remote Cord MC-22/MC-22A: Remote shutter release with blue,
yellow, and black terminals for connection to a remote
shutter-triggering device, allowing control via sound or
electronic signals (length 1 m/3 ft 3 in.).
• Remote Cord MC-30/MC-30A: Remote shutter release; can be
used to reduce camera shake (length 80 cm/2 ft 7 in.).
• Remote Cord MC-36/MC-36A: Remote shutter release; can be
used for interval timer photography or to reduce camera
shake or keep the shutter open during a time exposure
(length 85 cm/2 ft 9 in.).
• Extension Cord MC-21/MC-21A: Can be connected to ML-3 or
MC-series 20, 22, 22A, 23, 23A, 25, 25A, 30, 30A, 36, or 36A.
Only one MC-21 or MC-21A can be used at a time (length
3m/9ft 10in.).
• Connecting Cord MC-23/MC-23A: Connects two cameras with
ten-pin remote terminals for simultaneous operation
(length 40 cm/1 ft 4 in.).
• Adapter Cord MC-25/MC-25A: Ten-pin to two-pin adapter cord
for connection to devices with two-pin terminals,
including the MW-2 radio control set, MT-2
intervalometer, and ML-2 modulite control set (length
20 cm/8 in.).
• WR Adapter WR-A10: An adapter used to connect WR-R10
wireless remote controllers to cameras with ten-pin
remote terminals.
• GPS Unit GP-1/GP-1A (0 238): Record latitude, longitude,
altitude, and UTC time with pictures.