Nikon F100 - Lcd Panel

100
LCD panel Viewfinder
HI appears HI appears
Lo appears Lo appears
Electronic Electronic
analog exposure
analog exposure
display blinks display blinks
buLb blinks buLb blinks
¡ or ™ blinks A appears
Shutter speed 25o appears
indication blinks
Cause
• Overexposure may
have occurred.
• Underexposure may
have occurred.
• Subject brightness is
beyond camera’s
exposure range.
• Shutter speed is set to
buLb in S mode.
• Non-CPU lens is
attached, or no lens is
attached in P or S
mode.
• Shutter speed faster
than sync speed is
selected in S or M
mode.
Page
46-51
48
50
46-51
48
50
53
48, 62
32,
46,
48-53
84
Remedy
• In P mode, use ND filter.
• In S mode, select faster
shutter speed.
• In A mode, select smaller
aperture (larger f-
number).
(If the warning indication
remains after performing
above remedies in S or A
mode, use ND filter as
well.)
• In P mode, use flash.
• In S mode, select slower
shutter speed.
• In A mode, select larger
aperture (smaller f-
number).
(If the warning indication
remains after performing
above remedies in S or A
mode, use flash as well.)
• When the subject is bright,
use ND filter and when the
subject is dark, use flash.
• Cancel the buLb by
selecting 30 sec. or faster
shutter speed, or select M
mode to perform Long
Time Exposure.
• If non-CPU lens is
attached, set the
exposure mode to A or M.
• Release the shutter as it
is to take a flash picture.
(Shutter speed
automatically shifts to
1/250 sec.)
Troubleshooting
—continued
F100_En_16 7/8/05 8:06 PM Page 100