84
Using the Speedlight
• Operation described in this section applies when the SB-800, SB-600,
SB-80DX, SB-50DX, SB-28/28DX, SB-27, SB-26 or SB-25 Speedlight and
D- or G-type Nikkor are attached, and Automatic Balanced Fill-Flash with
TTL Multi Sensor is used.
1
Attach the Speedlight and set the metering system.
• Set the metering system to Matrix or Center-Weighted Metering.
2
Set the exposure mode and confirm shutter speed
and aperture.
• When using Red-Eye Reduction with Slow Sync or Slow Sync, set the
exposure mode to Programmed Auto or Aperture-Priority Auto.
• Available shutter speed and aperture in each exposure mode
Exposure mode Available shutter speed Available aperture Page
Programmed Auto
Automatically set
Automatically set
46
(1/250-1/60 sec.)
Shutter-Priority Auto 1/250-30 sec.* 48
Aperture-Priority Auto
Automatically set
Desired setting
50
(1/250-1/60 sec.)
Manual 1/250-30 sec.*, Bulb 52
* Shutter speed changes automatically to 1/250 sec. when the shutter speed is set to
1/250 sec. or faster as soon as the attached optional Speedlight is turned on.
3
Set the flash sync mode.
• Red-Eye Reduction and Red-Eye Reduction with Slow Sync can only be
set with the SB-800, SB-600, SB-80DX, SB-50DX, SB-28/28DX, SB-27 and
SB-26.
• With the SB-26 and SB-25, Front- and Rear-Curtain Sync settings on the
Speedlight override the setting on the camera body.
4
Set the power switch of the Speedlight to ON (or
STBY) and set the flash mode to TTL auto flash.
• Set TTL with the SB-800, SB-600, SB-80DX, SB-50DX, SB-28/28DX, SB-
26 or SB-25 and AUTO with SB-27.
F100_En_16 7/8/05 8:06 PM Page 84
To Next Page
Loading...
