Nikon F100 - Page 75

75
Custom Setting
Example: When AF Zoom-Nikkor 70-210mm f/4-5.6 is attached and f/8 (two
steps from the maximum aperture of f/4) at 70mm is set on the lens,
zooming up to 210mm does not change the aperture of f/8 with “0: Aperture
value remains” setting. However, when the “1: Aperture step from the lens’
maximum remains” is selected, aperture changes to f/11, two steps from the
maximum aperture of f/5.6 at 210mm.
20.Shutter release confirmation with self-timer LED
Options 0: Disabled (initial setting)
1: Enabled
At default setting, the self-timer LED only lights in the self-timer operation.
However, it can be set to light immediately before shutter release in normal
operation.
21.AE-L/AF-L button options (page 41/54)
Options 0: Simultaneous Auto Exposure/autofocus lock operation (initial
setting)
1: Auto Exposure lock only
2: Autofocus lock only
3: Auto Exposure lock remains after removing finger from the
button
At default setting, Auto Exposure and autofocus are locked simultaneously
when the ‚ button is pressed. However, it can be set to be locked
separately or exposure remains locked after removing your finger from the
button and released when the ‚ button is pressed again or picture is taken.
22.Aperture setting with lens’ aperture ring (pages 50-53)
Options 0: Disabled (initial setting)
1: Enabled
At default setting, aperture can be set using the Sub-Command Dial in
Aperture-Priority Auto or Manual exposure mode. However, it can be set to
be changed using the lens’ aperture ring with CPU Nikkor lens other than G-
type.
• Aperture will be displayed in one steps and regardless of the setting in
Custom Setting menu 12, the aperture can only be selected using the lens’
aperture ring.
F100_En_16 7/8/05 8:06 PM Page 75