C–1
C
Flash Modes
Flash Modes
C
i-TTL Mode
Information obtained by monitor pre-fl ashes and exposure control information is
integrated by the camera to automatically adjust fl ash output levels.
To take pictures using the SB-910 set in i-TTL mode, see “Basic Operations” •
(0B-6).
Either the i-TTL balanced fill-flash mode or the standard i-TTL mode option is •
available.
i-TTL balanced fill-flash
The fl ash output level is automatically adjusted for well-balanced exposure of the
main subject and background. appears on the LCD.
Standard i-TTL
The main subject is correctly exposed regardless of background brightness. This is
useful when you want to highlight the main subject. appears on the LCD.
t Camera’s metering mode and i-TTL mode
When the camera’s metering mode is changed to spot metering while i-TTL •
balanced fill-flash is in use, the i-TTL mode automatically changes to the standard
i-TTL mode.
The i-TTL mode automatically changes to i-TTL balanced fill-flash, after changing •
the camera’s metering mode to matrix or center-weighted.
To Next Page
Loading...
