30
APN: APN (Access Point Name) is used to identify the service type. Enter the APN provided by your 3G ISP.
Dial Number: Enter the dial number provided by your 3G ISP.
Idle time (in sec.): If no traffic for the preset time, the 3G will disconnect automatically.
Net Select: Select the 3G network that is available. You may select EVDO, WCDMA, CDMA2000, TD-SCDMA, GSM,
or Auto.
Dial on demand: Within the preset minutes, if the modem does not detect the flow of the user continuously, the
modem automatically stops the 3G connection. Once it detects the flow (like access to a webpage), the modem restarts
the 3G dial-up.
Dial Delay (in sec.): The 3G delays dial after the DSL is disconnected.
Default WAN Connection Select: You can select DSL or 3G from the drop-down list.
WAN back mechanism: The 3G connection is backup for the DSL connection.
DSL: If the DSL is disconnected, the 3G starts to dial.
IP connectivity: If the system fails to ping the specified IP address, the 3G starts to dial.
After finishing setting, click the Apply/Save button to save the settings.
You may also click the auto setting button to automatically configure the 3G connection.
After clicking the Apply/Save button, the following page appears.
If the 3G network card is installed, you may click the button on the Action column to establish or disconnect the 3G
connection.
NOTE! When there is no DSL WAN connection, insert the 3G network card, and then system will perform dial-up
automatically. If the DSL WAN connection and the 3G connection coexist, the DSL WAN connection takes priority over
the 3G connection. When the DSL WAN connection starts to perform dial-up, the 3G connection will be disconnected. If
the DSL WAN connection has established, you may manually perform 3G dial-up, and then the DSL WAN connection will
be disconnected.
WIND: internet.wind.it or internet.wind.biz or internet.wind
TIM: ibox.tim.it
Vodafone:mobile.vodafone.it
TRE: tre.it
Poste Mobile: internet.postemobile.it
CoopVoce: ibox.tim.it
To Next Page
Loading...
Need help?
General