73
SYSTEM LOG
Choose Management > System Log to display the following page.
In this page, you are allowed to configure the system log and view the security log.
Click the View System Log button to display the following page.
In this page, you can view the system log.
Click the Refresh button to refresh the system log. Click the Close button to exit.
Click the Configure System Log button to display the following page.
In this page, you can set 3 types of system log modes, including Local, Remote, and Both.
Local: When selecting Local, the events are recorded in the local memory.
Remote: When selecting Remote, the events are sent to the specified IP address and UDP port of the remote system
log server.
Both: When selecting Both, the events are recorded in the local memory or sent to the specified IP address and UDP
port of the remote system log server.
After finishing setting, click the Apply/Save button to save and apply the settings.
Note: If you want to log all the events, you need to select the Debugging log level.
To Next Page
Loading...
