4
WARNING
Copyright Statement
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means,
whether electronic, mechanical, photocopying, recording or otherwise without the prior writing of the publisher.
Windows™ 98SE/2000/ME/XP/VISTA/7/8 are trademarks of Microsoft
®
Corp. Pentium is trademark of Intel. All copyright
reserved.
The Nilox logo is a registered trademark. All other names mentioned may be trademarks or registered trademarks of their
respective owners. Subject to change without notice. No liability for technical errors and/or omissions.
Safety Precautions
Please read the following instructions carefully in order to avoid any risk or damage to the device caused by fire or electric
power failure:
Only qualified personnel should carry out any technical work on the device
Use the type of power marked on the volume label
Use the power adapter included in the device package
Pay attention to the power load of the outlet or extension lines. An overloaded power outlet or damaged lines and plugs
may cause electric shock or fire accident. Check the power cables regularly. In case of damage, replace the component
at once
Proper space left for heat dissipation is necessary to avoid damage caused by overheating to the device. The long and
thin holes on the device are designed for heat dissipation to ensure that the device works normally. Do not cover these
heat dissipation holes
Do not put this device close to a heat source or in a place with high temperatures. Do not expose it to direct sunlight.
Keep this device in a dry place. Do not spill any fluid on this device
Do not connect this device to any PCs or electronic products, unless our customer engineer or your broadband
provider gives you exact instructions on how to operate, as any wrong connection may cause power damage or fire risk.
Do not place this device on an unstable surface or support
When cleaning, avoid using cleaning sprays or any product containing alcohol or other flammable liquids
Avoid overheating. This may reduce the life of the device
Protect your device from humidity, direct sunlight as well as high and extremely low temperatures
Do no place any liquids on or close to the unit
If the device is brought from a cold environment into a warmer installation site, condensation may occur. Wait until the
temperature of the device has normalized. The unit should be completely dry before you connect it to AC main
Please use the supplied AC/DC Adapter included in the package. If you connect it to other devices, this product or
power supply unit may be damaged
We recommend you to place the device on a non-slip surface
Please note that the rubber/plastic feet on the devices may damage the surface
Check the cable regularly. Damaged cables must be replaced immediately
Ensure that no objects enter the connection sockets
Do NOT upgrade firmware over a wireless connection. Failure of the device may result. Use only hard-wired network
connections
Restoring a saved configuration file generated with another firmware version may render your Router unstable and some
functions may not work properly. After upgrading, please reset the router to factory default settings, then manually re-
enter your settings
Unplug ADSL Line and connect it to the Router using only 1 Ethernet port
Please pay attention. Any electrical shutdown during this procedure may cause malfunctioning
When uploading a software to the Router, it is important not to interrupt the Web browser by closing the window or
loading a new page. If the browser is interrupted, it may corrupt the software
To Next Page
Loading...
Need help?
General