9
PPPOE/PPPOA
PPPoA/PPPoE is an ADSL connection known as dial-up DSL. PPPoA/PPPoE has been created to integrate large band
services paying particular attention to an easy configuration. The user can obtain a high access speed and he can also share
the same account with the ISP. Let’s see how to configure correctly this kind of ADSL configuration.
In case of PPPoE (left picture) choose VPI=8, VCI=35 and Encapsulation Mode=LLC/SNAP Bridging and
Protocol=PPPoE
In case of PPPoA (right picture) choose VPI=8, VCI=35 and Encapsulation Mode=VC/MUX and
Protocol=PPPoA
Insert Username and Password (check with ISP), now you will be able to change the SSID. Click on Apply/Save, then
Next.
The Setup Wireless wizard is now completed. After some minutes the Internet LED will be lit in green.
In order to verify the WAN Status, please click Device Info->WAN.
Pay attention to the WAN-ADSL connection. If you have any doubt turn to qualified personnel or contact Nilox technical
assistance. Nilox will not be considered responsible in case of wrong or bad configuration.
To Next Page
Loading...
Need help?
General