Nilox DAS-1410 User Manual

26
WAN SERVICE(IPOA)
This section describes the steps for adding the IPoA WAN service.
 Step0 Choose Advanced Setup > Layer2 Interface > ATM Interface . In this page, you can add or remove to
configure DSL ATM Interfaces. Click Add to add ATM Interface and the following page appears. DSL Link Type:
IPoA and select the encapsulation mode to be LLC/SNAP-Routing (according to the uplink equipment). Click
Apply/Save to save the configuration, and return the following page.
 Step1 Choose Advanced Setup > WAN Service, and the following page appears. Click Add. In the Wide Area
Network (WAN) Service Setup page, click the Add button to display the following page. (At first, you must add a proper
ATM interface for this WAN service).
 Step 2 In this page, you can select a ATM Interface for the WAN service. After selecting the ATM interface, click Next
to display the following page.
 Step 3 In this page, Click Next.

Nilox DAS-1410 Specifications

General

Brand	Nilox
Model	DAS-1410
Category	Network Router
Language	English