7210 SAS-D CHASSIS INSTALLATION GUIDE Configuring the System
Issue: 08 3HE 10087 AAAA TQZZA Edition 01 55
5.2 Initializing the System and Downloading
Software
The 7210 SAS-D ships with bootloader and TiMOS software on the compact flash
memory device. When the system is powered up for the first time, the bootloader will
attempt an auto-init procedure (see the System Basics Guide for more information).
However, the auto-init can be interrupted and the boot operation controlled manually.
5.2.1 Booting in the Lab
There are several ways to boot the 7210 SAS-D from the network. You can choose
to boot the device using one of the following options:
• Using the image shipped along with the 7210 SAS-D to boot the device
• Using the network to load the image and boot the device
By default the device is configured to use the network to load the image. The
following sections describe how to boot the device using either of the options listed
above.
5.2.1.1 Booting Using the Image on Flash
You will need the following:
• A PC with a serial port and hyperterminal
• An RJ-45 serial cable that connects the console port of 7210 SAS-D to the
serial port of a PC
Connect the 7210 SAS-D console port to serial port of the PC and then power up the
7210 SAS-D. The system will start booting up with messages on the console similar
to those shown below. Follow the prompts given below to boot the system with the
image on the flash.
Resetting...OK
Nokia 7210 Boot ROM. Copyright 2009-2011 Nokia.
All rights reserved. All use is subject to applicable license agreements.
Testing ROM load area...done
Relocating code...Jumping to RAM
Performing second stage RAM test....passed
Board Serial Number is 'NS1111C0115'
Bootlog started for Version A-V-3.0.B5-85
Build V-3.0.B5-85 bootrom/mpc 7xxx
To Next Page
Loading...
