Nokia 7210 - Page 57

7210 SAS-D CHASSIS INSTALLATION GUIDE Configuring the System
Issue: 08 3HE 10087 AAAA TQZZA Edition 01 59
• The TiMOS software image
• A PC with a serial port and Hyperterminal
• An RJ-45 serial cable that connects the console port of 7210 SAS-D to the
serial port of PC
• A network cable to connect the 7210 SAS-D to the network
Prepare the setup as shown in Figure 22.
When you are done, power on the 7210 SAS-D.
Using the uplink port to boot the 7210 SAS-D from the network:
Resetting...OK
Nokia 7210 Boot ROM. Copyright 2009-2011 Nokia.
All rights reserved. All use is subject to applicable license agreements.
Testing ROM load area...done
Relocating code...Jumping to RAM
Performing second stage RAM test....passed
Board Serial Number is 'NS1111C0115'
Bootlog started for Version A-V-3.0.B5-85
Build V-3.0.B5-85 bootrom/mpc 7xxx
Built on Wed Apr 20 13:52:05 IST 2011 by builder in /builder/3.0B5/panos/main
?Attempting to load from file cf1:/boot.tim
Version L-3.0.B5-85, Wed Apr 20 14:13:38 IST 2011 by builder in /builder/3.0B5/panos/
main
text:(4782384-->20108848) + data:(1084015-->3891872)
Starting at 0xb000000...
PCIe: Port 0 Link UP
Total Memory: 512MB Chassis Type: sas Card Type: badami_7210
TiMOS-L-3.0.B5-85 boot/mpc NOKIA SAS-D 6F4T 7210 Copyright (c) 2000-2011 Nokia.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 14:13:38 IST 2011 by builder in /builder/3.0B5/panos/main
TiMOS BOOT LOADER
Time from clock is THU APR 21 11:03:21 2011 UTC
Switching serial output to sync mode... done
Since the switch does not ship with a BOF, it will show the default settings.
Looking for cf1:/bof.cfg ... not found
Could not find bof.cfg on any of the local drives.
Default Settings:
------------------------------------------------------------------------------------
-------------
Contents of Boot Options File on cf1:
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0