AT Command Set for Nokia 8210 12
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
<name>:
0
data circuit asynchronous (UDI or 3.1 kHz
modem)
1
data circuit synchronous (UDI or 3.1 kHz
modem)
2
PAD Access (asynchronous) (UDI)
3
Packet Access (synchronous) (UDI)
4
data circuit asynchronous (RDI)
5
data circuit synchronous (RDI)
6
PAD Access (asynchronous) (RDI)
7
Packet Access (synchronous) (RDI)
also all other values below 128 are
reserved
<ce>:
0
transparent
1
non-transparent
2
both, transparent preferred
3
both, non-transparent preferred
+CCFC Call Forwarding Number and Conditions
Controls call forwarding supplementary services. <reason> values 4 and 5 are only
applicable for <mode>=0. When status request response from network indicates that
SS is active for specific data bearer services (e.g. 'circuit async'), AT interface shall
only indicate 'data' (<class>=2) ('not active' case is displayed only when SS is not
active to any service; i.e. +CCFC: 0,7). (GSM 07.07 section 7.10.)
Syntax:
AT+CCFC=<reason>,
<mode>,<number>,
<type>,<class>,
<subaddr>,
<satype>, <time>
When <mode>=2 the response is +CCFC:
<status>,<class1>[,<number>,<type>
[,<subaddr>,<satype>[,<time>]]]
[<CR><LF>+CCFC:
<status>,<class2>[,<number>
,<type>[,<subaddr>,<satype>[,<time>]]]
[...]].
The default option is [,,, 129/145,7
,,128,20]
AT+CCFC=?
Show supported values.
Parameters:
<reason>:
0
unconditional
1
mobile busy
2
no reply
3
not reachable
4
all call forwarding (GSM 02.30)
5
all conditional call forwarding (GSM 02.30)
<mode>:
0
disable
1
enable
2
query status
3
registration
4
erasure
<number>: string type phone number of forwarding address in format specified by
<type>
<type>: type of address octet in integer format (GSM 04.08, subclause 10.5.4.7);
default 145 when dialling string includes international access code character "+",
otherwise 129
<subaddr>: string type subaddress of format specified by <satype>
To Next Page
Loading...
Need help?
General
