Nokia 8210 - Profiles (Menu 3)

AT Command Set for Nokia 8210 49
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
L Monitor Speaker Loudness
This setting is ignored. It is included for compatibility reasons. (V.25ter section
6.3.13.)
Syntax:
ATL[<n>]
L[0]...L3
M Monitor Speaker Mode
This setting is ignored. It is included for compatibility reasons. (V.25ter section
6.3.14.)
Syntax:
ATM[<n>]
M[0]...M2
O Return to On-Line Data State
This command is used when you have made a connection with the remote device
and have escaped (with the +++ command) to the command mode. Give the
command to return from the (on-line) command mode to normal on-line operation.
(V.25ter section 6.1.2.)
Syntax:
ATO[<n>]
Go to on-line state. Response is
CONNECT [<speed>].
P Select Pulse Dialling
This setting is ignored. It is included for compatibility reasons. (V.25ter section 6.3.3.)
Syntax:
ATP
Q Result Code Suppression
This command determines whether responses are sent to the DTE or not. Affects
only result codes, not information responses. (V.25ter section 6.2.5.)
Syntax:
ATQ[0]
Enable sending of responses to DTE. This
is the default option.
ATQ1
Disable sending of responses to DTE
S0 Automatic Answer
Value indicates number of rings (RING or +CRING result codes) to wait before
answering automatically. Value 0 disables auto-answer. (V.25ter section 6.3.8.)
Syntax:
ATS0=<n>
Values for <n> are 0..255 (default 0).
ATS0?
Query current setting.
Response is <n>.
S1 Ring Count
Returns number of rings (RING or +CRING result codes) counted after last MT call
setup. (De facto.)
Syntax:
ATS1?
Query current setting.
Response is <n>. Values for <n> are
000..255.
S2 Escape Code Character
The default character is a plus sign. See also the command +++ Escape at page 10.
(De facto.)