AT Command Set for Nokia 8210 39
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CSQ Signal Quality
Returns signal strength as calculated by ME. Bit error rate reporting not supported by
NMP products. (GSM 07.07 section 8.5.)
Syntax:
AT+CSQ
Response is +CSQ: <rssi>, 99
AT+CSQ=?
Show supported values.
Response is +CSQ: (list of supported
<rssi>'s), (99)
Parameters:
<rssi>:
0
-113 dBm or less
1
-111 dBm
2...30
-109... -53 dBm
31
-51 dBm or greater
99
not known or not detectable
+CSSN Supplementary Service Notifications
Controls presentation of +CSSI intermediate result code and +CSSU unsolicited
result code. (GSM 07.07 section 7.16.)
Syntax:
AT+CSSN=<n>,<m>
The default option is 0, 0.
AT+CSSN?
Query current setting.
Response is +CSSN: <n>,<m>
AT+CSSN=?
Show supported values.
Response is +CSSN: (list of supported
<n>'s), (list of supported <m>'s)
Parameters:
<n>:
parameter sets/shows the +CSSI result
code presentation status in the TA:
0
disable
1
enable
<m>:
parameter sets/shows the +CSSU result
code presentation status in the TA:
0
disable
1
enable
<code1>:
it is manufacturer specific, which of these
codes are supported:
0
unconditional call forwarding is active
1
some of the conditional call forwardings
are active
2
call has been forwarded
3
call is waiting
4
this is a CUG call (also <index> present)
5
outgoing calls are barred
6
incoming calls are barred
7
CLIR suppression rejected
8
call has been deflected
To Next Page
Loading...
Need help?
General
