AT Command Set for Nokia 8210 48
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Result Codes
All result codes are not in V.25ter. Before one of the above codes may be returned
some of the following: +CSSI, +COLP, +CR (or CARRIER), +ER, +DR, or +ILRR (in
that order). Available connection rates depend on the product.
possible verbose
result codes (V1)
numeric
(V0) description
BLACKLISTED
14 call to the number is forbidden until manual reset
BUSY 7 called party is busy
CONNECT 1 data/fax call established; rate 300 bps (or X
forbids rate display)
CONNECT 1200
5 data/fax call established; rate 1200 bps
CONNECT 2400 10 data/fax call established; rate 2400 bps
CONNECT 4800 11 data/fax call established; rate 4800 bps
CONNECT 9600 12 data/fax call established; rate 9600 bps
CONNECT 14400 17 HSCSD (or 14.4 tch) data/fax call established;
rate 14400 bps
CONNECT 19200 18 HSCSD data/fax call established; rate 19200 bps
CONNECT 28800 19 HSCSD data/fax call established; rate 28800 bps
DELAYED 13 call to the number is temporarily (5 sec - 3 min)
forbidden
ERROR
4 command cannot be actioned
NO ANSWER 8 called party does not answer
NO CARRIER 3 call could not be established
OK 0 command aborted or voice call started with
semicolon character
E Command Echo
This command determines whether characters that are received from the DTE are
echoed or not in the command mode. (V.25ter section 6.2.4.)
Syntax:
ATE[0]
Disable echoing
ATE1
Enable echoing. This is the default option.
H Hang Up Call
This command normally hangs up the call. If the alternating call data mode is
currently active, ATH does not hang up the call but call mode is switched from data to
voice. If you want to disconnect the alternating call, you must use the AT+CHUP
command instead. (V.25ter section 6.3.6.)
Syntax:
ATH[<n>]
Hang up call. <n>=0
I Request Identification Information
This command displays information on the TA. (V.25ter section 6.1.3.)
Syntax:
ATI[0]
Displays the TA manufacturer
identification (same as for +GMI).
ATI1
Displays the product serial number (same
as for +GSN).
ATI2
Displays the product version (same as for
+GMR).
ATI3
Displays the product name (same as for
+GMM).
ATI4...ATI13
Dummy values that are just accepted.
To Next Page
Loading...
Need help?
General
