AT Command Set for Nokia 8210 47
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Syntax:
A semicolon character needs be added when a voice call is originated.
ATD[<dial_string>[;]]
Dials the number in a dial_string.
ATD> mem<n> [;]
Originate call to phone number found from
location in a specific memory mem, which
is one of the two letter memory
abbreviations as returned by +CPBS=?
(without double quotes); location range
can be queried with +CPBR=?; note that
in case of SIM ADN memory (SM) also
D>SIM shall be accepted (due to
inconsistency in 07.07).
ATD><n> [;]
Dials a stored number from a data
software memory location <n>.
ATD[;]
Dials a stored number from a data
software memory location 0.
ATD> <string>
Dial a number assigned to name <string>.
ATDL
Redials the last number that has been
dialled during the current session.
<dial-string> Characters
<dial-string> characters values description
V.25ter dialling digits
0123456789+ accepted as valid digits
*#ABCD cause ERROR
V.25ter modifiers , in case of voice call: originate call to
the number preceding comma, wait for
remote answer, pause for length
specified with S8 register, and send
numbers after comma as DTMF digits;
further commas cause pause for
length specified with S8 register (all
commas are ignored in case of data
call)
T P ! W @ accepted but ignored
V.25ter semicolon ; voice call originating (must be last
character in command line)
GSM 07.07 modifiers > direct dialling from phonebook (must
be first char after D) (see next table)
i allow calling line id presentation for
this call
I restrict calling line id presentation for
this call
G control CUG information for this call;
use +CCUG values
de facto L redial to the number last dialled
See also 07.07 section 6.2 and V.25ter sections 6.3.1.1-6.3.1.7. For voice call
example refer 07.07 annex G. Note that I is the only case-sensitive dial-string
character.
To Next Page
Loading...
