AT Command Set for Nokia 8210 22
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
display events, which are not caused by
+CDIS shall be indicated by the TA to the
TE. Character set used in <text> is as
specified by command Select TE
Character Set +CSCS
2
display event reporting using result code
+CDEV: <elem>,<text>. All display events
shall be directed from TA to TE. Character
set used in <text> is as specified by
command Select TE Character Set
+CSCS
<ind>:
0
no indicator event reporting
1
indicator event reporting using result code
+CIEV: <ind>,<value>. <ind> indicates the
indicator order number (as specified for
+CIND) and <value> is the new value of
indicator. Only those indicator events,
which are not caused by +CIND shall be
indicated by the TA to the TE
2
indicator event reporting using result code
+CIEV: <ind>,<value>. All indicator events
shall be directed from TA to TE
+CMGC Send Command
Text/PDU entering as specified in 07.05. If SMSC address is not set/restored during
the current session (i.e. +CSCA? returns +CSCA: "",129) it must be automatically
read from SIM/ME (location 1). In PDU mode, all kind of GSM 03.40 MO TPDUs can
be sent with this command (operation equals to +CMGS). (GSM 07.05 section 3.5.5.)
Syntax:
text mode (+CMGF=1):
AT+CMGC=<fo>,<ct>,<pid>,
<mn>,<da>, <toda><CR>
text is entered <ctrl-Z/ESC>
Response is (+CMGF=1) and sending ok:
+CMGC: <mr>[,<scts>]
Default option is text mode
[2,0,0,0,"",129/145]
PDU mode (+CMGF=0):
AT+CMGC=<length><CR>
PDU is given <ctrl-Z/ESC>
Response is (+CMGF=0) and sending ok:
+CMGC: <mr>[,<ackpdu>]
AT+CMGC=?
Shows whether command has been
implemented.
+CMGD Delete Message
Execution command deletes message from preferred message storage <mem1>
location <index>. If deleting fails, final result code +CMS ERROR: <err> is returned.
(GSM 07.05 section 3.5.4.)
Syntax:
AT+CMGD=<index>
AT+CMGD=?
Shows whether command has been
implemented.
+CMGF Message Format
This command tells the TA, which input and output format of messages to use.
<mode> indicates the format of messages used with send, list, read and write
commands and unsolicited result codes resulting from received messages. Mode can
be either PDU mode (entire TP data units used) or text mode (headers and body of
the messages given as separate parameters). Text mode uses the value of
parameter <chset> specified by command Select TE Character Set +CSCS to inform
the character set to be used in the message body in the TA-TE interface. (GSM
07.05 section 3.2.3.).
To Next Page
Loading...
Need help?
General
