Nokia 8210 - Last Number Redial; Voice Mailbox; Speed Dialling

AT Command Set for Nokia 8210 18
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CLCC List Current Calls
Returns list of currently available calls in ME. (GSM 07.07 section 7.17.)
Syntax:
AT+CLCC
Response is [+CLCC: <id1>, <dir>,
<stat>, <mode>, <mpty>[,,,<alpha>]
[<CR><LF>+CLCC: <id2>, <dir>, <stat>,
<mode>, <mpty> [,,,<alpha>] [...]]]
AT+CLCC=?
Shows whether command has been
implemented.
Parameters:
<idx>: integer type; call identification number as described in GSM 02.30, subclause
4.5.5.1; this number can be used in +CHLD command operations
<dir>:
0
mobile originated (MO) call
1
mobile terminated (MT) call
<stat> (state of call):
0
active
1
held
2
dialing (MO call)
3
alerting (MO call)
4
incoming (MT call)
5
waiting (MT call)
<mode> (bearer/teleservice):
0
voice
1
data
2
fax
3
voice followed by data, voice mode
4
alternating voice/data, voice mode
5
alternating voice/fax, voice mode
6
voice followed by data, data mode
7
alternating voice/data, data mode
8
alternating voice/fax, fax mode
9
unknown
<mpty>:
0
call is not one of multiparty (conference)
call parties
1
call is one of multiparty (conference) call
parties
<number>: string type phone number in format specified by <type>
<type>: type of address octet in integer format (GSM 04.08, subclause 10.5.4.7)
<alpha>: string type alphanumeric representation of <number> corresponding to the
entry found in phonebook; used character set should be the one selected with
command Select TE Character Set +CSCS
+CLCK Facility Lock
Enables/disables or queries the state of SIM/ME security features (PIN/security code
query or fixed dialling feature) or call barring supplementary services. <fac> values
"AB", "AG" and "AC" are only applicable for <mode>=0. Only security code levels
'phone' and 'none' can be handled with this command. If 'memory' level is set and
status is queried (+CLCK="PS",2), AT interface shall indicate 'not active' (+CLCK: 0).
When SS status request response from network indicates that SS is active for
specific data bearer services (e.g. 'circuit async'), AT interface shall only indicate
'data' (<class>=2) ('not active' case is displayed only when SS is not active to any
service; i.e. +CLCK: 0,7). (GSM 07.07 section 7.4.)