AT Command Set for Nokia 8210 20
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
<classx>:
is a sum of integers each representing a
class of information (default 7 equals to all
classes):
1
voice
2
data
4
fax
also all other values below 128 are
reserved
+CLIP Calling Line Identification Presentation
Controls presentation of +CLIP unsolicited result code or returns CLIP subscription
status from network. If product does not support network status query, <m> shall
always equal 2. (GSM 07.07 section 7.6.)
Syntax:
AT+CLIP=<n>
The default option is 0.
AT+CLIP?
Query current setting.
Response is +CLIP: <n>,<m>
AT+CLIP=?
Show supported values.
Response is +CLIP:(list of supported
<n>'s).
+CLIR Calling Line Identification Restriction
Enables/disables own number sending to network or returns CLIR subscription status
from network. If product does not support network status query, <m> shall always
equal 2. (GSM 07.07 section 7.7.)
Syntax:
AT+CLIR=<n>
The default option is 0.
AT+CLIR?
Query current setting.
Response is +CLIR: <n>,<m>
AT+CLIR=?
Show supported values.
Response is +CLIR: (list of supported
<n>'s).
+CMEE Report Mobile Equipment Error
This command controls the presentation of extended error information result code.
See also result code +CME ERROR. (07.07 section 9.1.)
Syntax:
AT+CMEE=<n>
Default option is 0.
AT+CMEE?
+CMEE: <n>
AT+CMEE=?
Response is +CMEE: (list of supported
<n>'s).
Parameters:
<n>:
0
disable +CME ERROR: <err> result code
and use ERROR instead
1
enable +CME ERROR: <err> result code
and use numeric <err> values
2
enable +CME ERROR: <err> result code
and use verbose <err> values
To Next Page
Loading...
